Update 3
Holidays have been a bit of a busy away from the car! Hoping to get back on schedule after the new year.
I did however get a few things done:
- Front end is fully assembled minus front sway bar I’m still deciding if I want to install one or not.
- Axles are assembled
- See drivetrain section for more detail. This was a bit more difficult tell I found the hose clap trick.
- Floor pan had to be removed. I jumped the gun and forgot to weld in seat brackets and harness mounts.
- Waiting on seat mounts to come in before I can get to welding.
- Mounting plates had there quality inspection by boost.
- Installed Brake master cylinder.
- I recommend using longer bolts for install. Factory five hardware seems far to short.
- Notice my intake pipe had a rip in the section that clamps onto the turbo. Removed the old hose in preparation for when my new hose arrives. I found that cutting out the old one was far more easy versus trying to take it out as one
