Update 20
Build status

Update 20

Headlight bucket install Finally solved my headlights. I tried using fasteners on the bottoms and it didn't work how I wanted. So I ended up having to get new buckets from FFR. The new ones are n...
Read More
Update 19
Build status

Update 19

Small Update I started working on my dash set up. Still working on finishing things up but my center console is starting to fit in nicely Also and old picture I forgot to upload a while ago with s...
Read More
Update 18
Build status

Update 18

Finished up my exhaust last night. I need to weld up support mounts and then get it all wrapped up with heat wrap. It was my 1st time welding up a complex exhaust while my welds did not come out perfe...
Read More
Update 17
Build status

Update 17

Got my wireless steering wheel up and running! No more wires running up the steering column yay! Red buttons are left and right turn signals and the of course the horn. I can even honk the horn and us...
Read More
Update 16
Build status

Update 16

Bodywork has finally started! So far just got the bumper underway! Exhaust not made yet! Tips just laying around atm Here are a is a picture of the reinforcement rods that are fiber glassed in ...
Read More
Update 15
Build status

Update 15

Well the time has come for the body to start being installed. I have been avoiding it! With my list getting smaller and smaller I plan to get the body installed this weekend/next week. I was hopping t...
Read More
Update 14
Build status

Update 14

Update on my interior its coming together! Sadly I have been pretty busy with rallycross at the moment so I haven't been able to get loads done, but I have managed to get half the interior done and go...
Read More
Update 13
Build status

Update 13

I was having fuel starvation issues going up my hill when I had 5 gallons or less of gas in the tank. My hill to my house is very steep and my fuel pickup was sucking in air and stalling out my car. I...
Read More
Update 12
Build status

Update 12

I just found out my 98 trans won't work so time to swap in a 2014 wrx trans! Manged to get the 2014 WRX trans in I didn't feel like sourcing axles again so I bought the pre-assembled units form FFR...
Read More
Update 11
Build status

Update 11

Went out for the 1st drive! Went good and bad... Good the car runs and drives bad the after market front axle stubs I bought are machined wrong so my wheel bearing comes out. Anyone have extra stubs? ...
Read More